When is a different start code allowed? - E1.20 RDM (Remote Device Management) Protocol Forums

prwatE120 · September 16th, 2008

Berntd

I spoke to the manufacturer concerned at PLASA, without referencing yiur specific report. They are aware that a number of their products have shipped (and are still shipping) with code that follows one of the drafts of the standard rather than the ANSI release. Such products generally allow firmware updates and they are working towards ANSI compliant code for these. I suggest you contact them directly to register for new firmware when it becomes available.

Peter Willis

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sub-device response to SET/GET DMX512 start address	p_richart	RDM Interpretation Questions	2	September 29th, 2006 09:27 AM
Slot Label Code	anstein	RDM General Implementation Discussion	1	August 10th, 2006 02:06 PM

September 16th, 2008	#7
prwatE120 Task Group Member Join Date: Jun 2006 Posts: 181	Berntd I spoke to the manufacturer concerned at PLASA, without referencing yiur specific report. They are aware that a number of their products have shipped (and are still shipping) with code that follows one of the drafts of the standard rather than the ANSI release. Such products generally allow firmware updates and they are working towards ANSI compliant code for these. I suggest you contact them directly to register for new firmware when it becomes available. Peter Willis