change parameter setting - E1.20 RDM (Remote Device Management) Protocol Forums

sblair · January 12th, 2017

The message to use to change the operating mode or DMX library that is used would be the DMX_PERSONALITY message.

There currently is not a standardized message for doing tunable white (i.e. changing Kelvin temperature) but you could do this by using a Manufacturer-specific message as explained in the standard.

ilek79 · January 12th, 2017

Thank you for Answer
as i understand, change parameter is using DMX_PERSONALITY and
Manufacture-specific massage.
another way is not possible.

thank you for answer.
think about Manufacture-specific massage.
have a good day.

January 12th, 2017	#1
sblair Administrator Join Date: Feb 2006 Posts: 441	The message to use to change the operating mode or DMX library that is used would be the DMX_PERSONALITY message. There currently is not a standardized message for doing tunable white (i.e. changing Kelvin temperature) but you could do this by using a Manufacturer-specific message as explained in the standard. __________________ Scott M. Blair RDM Protocol Forums Admin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Parameter Description for PIDs declared by SubDevice	prwatE120	RDM Interpretation Questions	3	April 1st, 2025 08:50 AM
PDL size and manufacturer specific parameter ID's	jamie	RDM General Implementation Discussion	5	July 13th, 2009 12:31 AM
Command Class / Parameter ID mismatch handling	dangeross	RDM Interpretation Questions	2	April 16th, 2009 01:39 PM

January 12th, 2017	#2
ilek79 Junior Member Join Date: Jan 2017 Posts: 3	Thank you for Answer as i understand, change parameter is using DMX_PERSONALITY and Manufacture-specific massage. another way is not possible. thank you for answer. think about Manufacture-specific massage. have a good day.