EUID Decode Errors - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · September 24th, 2014

Go into the discovery menu, then run "Send Single DUB" (I don't recall the exact menu name but it'll be similar to that).

Then, run "View Previous Response"

This will show you the exact data that the RDM Controller received from the 485 wire. Does it match what your responder is sending? If the response data is too early or too late, the DMXter won't accept it.

If you have a USB terminal attached, you can press RED and then select "Send All to USB". This will give you a record of everything that's happened recently, including packet data. You can post that here for further discussion.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Errors and Sub Device All Call	SeanSill	RDM General Implementation Discussion	2	July 19th, 2013 01:48 PM
errors when testing discovery	redwind	RDM General Implementation Discussion	1	July 20th, 2011 12:05 PM

September 24th, 2014	#14
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	Go into the discovery menu, then run "Send Single DUB" (I don't recall the exact menu name but it'll be similar to that). Then, run "View Previous Response" This will show you the exact data that the RDM Controller received from the 485 wire. Does it match what your responder is sending? If the response data is too early or too late, the DMXter won't accept it. If you have a USB terminal attached, you can press RED and then select "Send All to USB". This will give you a record of everything that's happened recently, including packet data. You can post that here for further discussion.