ACT_TIMER to Set messages - E1.20 RDM (Remote Device Management) Protocol Forums

sergeychk · April 18th, 2014

my question is about TIMER ACK. For case when my device need time to save DMX START ADDRESS to eeprom:

1)controller: SET_COMMAND DMX_START_ADDRESS
1)responder: SET_COMMAND_RESPONSE TIMER_ACK 2
wait 200ms
2)controller: GET_COMMAND QUEUED
2)responder: SET_COMMAND_RESPONSE ACK or GET_COMMAND_RESPONSE ACK?
SET if answer for transaction 1 or GET for transaction 2 what is correct?
and number of transactions for this case is 1 (for all this chart with same transaction number) or 2 (split it into 2 steps)? transaction it is send/receive or full done target operation?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ACK_TIMER, QUEUED Messages	berntd	RDM Interpretation Questions	1	November 12th, 2008 10:02 PM
get queued messages as a ping?	sondericker	RDM Interpretation Questions	2	January 20th, 2007 09:11 PM

April 18th, 2014	#3
sergeychk Junior Member Join Date: Apr 2014 Posts: 9	my question is about TIMER ACK. For case when my device need time to save DMX START ADDRESS to eeprom: 1)controller: SET_COMMAND DMX_START_ADDRESS 1)responder: SET_COMMAND_RESPONSE TIMER_ACK 2 wait 200ms 2)controller: GET_COMMAND QUEUED 2)responder: SET_COMMAND_RESPONSE ACK or GET_COMMAND_RESPONSE ACK? SET if answer for transaction 1 or GET for transaction 2 what is correct? and number of transactions for this case is 1 (for all this chart with same transaction number) or 2 (split it into 2 steps)? transaction it is send/receive or full done target operation?