RDM software/implementation - E1.20 RDM (Remote Device Management) Protocol Forums

nomis52 · April 2nd, 2013

I asked someone I know at ETC and this is what they replied with:

To get device feedback such as RDM errors in Congo you have to open the feedback tab found in the Browser->About->Dimmer/Device Feedback Log. If there are active RDM errors for PATCHED devices you will also get a notification in the header of each Congo window and on the patched device itself in Live.

To get more information on an attached RDM devices, first navigate to the Browser->Patching->RDM Device List. With this list open you can then select your desired RDM device and open more advanced properties. This is done by using the arrow keys and Enter or double clicking with a mouse in the "Parameters" or "Sensors" cell for the device you wish to look at. This will open another tab providing the detailed information on that device type. Unlike errors, RDM devices do NOT have to be patched to get this information.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RDM software system for POS	pbm888	RDM Marketplace Discussion	1	August 25th, 2011 12:03 PM
Partial RDM implementation?	svanciel	RDM General Implementation Discussion	7	November 7th, 2008 07:19 AM
Master Fader accross Rdm implementation Question	berntd	RDM General Implementation Discussion	1	May 9th, 2008 12:12 AM
ENTTEC RDM Software Available	nic123	RDM Marketplace Discussion	0	August 4th, 2006 01:38 AM
Welcome to the RDM General Implementation Discussion Forum	sblair	RDM General Implementation Discussion	0	May 31st, 2006 10:38 PM

April 2nd, 2013	#3
nomis52 Task Group Member Join Date: May 2010 Location: San Franciscio Posts: 57	I asked someone I know at ETC and this is what they replied with: To get device feedback such as RDM errors in Congo you have to open the feedback tab found in the Browser->About->Dimmer/Device Feedback Log. If there are active RDM errors for PATCHED devices you will also get a notification in the header of each Congo window and on the patched device itself in Live. To get more information on an attached RDM devices, first navigate to the Browser->Patching->RDM Device List. With this list open you can then select your desired RDM device and open more advanced properties. This is done by using the arrow keys and Enter or double clicking with a mouse in the "Parameters" or "Sensors" cell for the device you wish to look at. This will open another tab providing the detailed information on that device type. Unlike errors, RDM devices do NOT have to be patched to get this information.