Responders with multiple Responder Ports in a single Device. - E1.20 RDM (Remote Device Management) Protocol Forums

swisson · February 8th, 2011

Tanks for clarifying
Each port will act independently on RDM, they just may share some parameters.
If the controller will change a parameter which is shared on the device (per example: Label ) by using UIDa, on all others ports will be a message indicating that the label has changed.
So working with two or more controllers should work.
Right?

Should the primary port report a binding UID to itself or not?

Robert

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3.2.1 Responder Packet Timings	prwatE120	RDM Timing Discussion	6	May 23rd, 2009 08:32 AM
Any RDM Responder Devices out there yet?	sblair	RDM Marketplace Discussion	8	September 20th, 2006 06:03 AM

February 8th, 2011	#4
swisson Junior Member Join Date: Sep 2006 Posts: 2	Tanks for clarifying Each port will act independently on RDM, they just may share some parameters. If the controller will change a parameter which is shared on the device (per example: Label ) by using UIDa, on all others ports will be a message indicating that the label has changed. So working with two or more controllers should work. Right? Should the primary port report a binding UID to itself or not? Robert