|
|
|||||||
| RDM Interpretation Questions Discussion and questions relating to interpreting and understanding the E1.20 RDM Standard. |
|
|
Thread Tools | Search this Thread | Display Modes |
November 6th, 2008
|
#2 |
|
Administrator
Join Date: Feb 2006
Posts: 441
  |
Patrick,
The only message that is required to be supported for Sub-Devices is the SUPPORTED_PARAMETERS message. This is detailed in Section 9.3. There is no requirement for any other messages to be supported and as you point out some would not make sense. Of course there are Sub-Devices where IDENTIFY_DEVICE and SOFTWARE_VERSION_LABEL would be useful but it completely depends on the application.
__________________
Scott M. Blair  RDM Protocol Forums Admin |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multi-devices or sub-devices | Fokko | RDM Interpretation Questions | 4 | December 1st, 2006 11:10 AM |
| Any RDM Responder Devices out there yet? | sblair | RDM Marketplace Discussion | 8 | September 20th, 2006 06:03 AM |
Threaded Mode