Does controller need it's UID and support any PIDs? - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · January 18th, 2016

I'm a bit confused. Can you give more details about your setup and how things are connected? What controller are you using and what's wired to what?

There can only be one controller, and it doesn't need to discover itself or respond to any PIDs (It already knows everything about itself)

The Enttec USB boxes can be configured to run as an RDM Controller, or as an RDM responder (but they can't do both simultaneously). It sounds like yours might be configured to act as a responder. The ACK Timer behavior is common for USB-attached RDM Responders since the host computer can't guarantee it will respond within the 2ms response window.

I've only used the older Enttec USB boxes and you had to explicitly configure them to be a controller or a responder. It's possible that the newer NK2 units can auto-switch.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UID / EUID convertor	nomis52	RDM General Implementation Discussion	0	May 16th, 2015 11:50 AM
DISC_UNIQUE_BRANCH dest UID (section 7.3)	berntd	RDM Interpretation Questions	5	October 15th, 2008 09:06 PM

January 18th, 2016	#5
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	I'm a bit confused. Can you give more details about your setup and how things are connected? What controller are you using and what's wired to what? There can only be one controller, and it doesn't need to discover itself or respond to any PIDs (It already knows everything about itself) The Enttec USB boxes can be configured to run as an RDM Controller, or as an RDM responder (but they can't do both simultaneously). It sounds like yours might be configured to act as a responder. The ACK Timer behavior is common for USB-attached RDM Responders since the host computer can't guarantee it will respond within the 2ms response window. I've only used the older Enttec USB boxes and you had to explicitly configure them to be a controller or a responder. It's possible that the newer NK2 units can auto-switch.