|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
January 20th, 2007
|
#1 | |
|
Task Group Member
Join Date: Jun 2006
Posts: 181
|
Discovery Response Preamble
PLEASE remember that a controller is required to cope with a variable number of preamble bytes in responses to Discovery commands.
This is cleary stated in the last paragraph of section 7.5. Quote:
I have now encountered two controllers that could not cope with this! This would make them NON-COMPLIANT - but might only show up when they were used in conjunction with one or more layers of splitters. If you are interested I now have special test responders that can vary the number of preamble bytes returned ... regards Peter Willis |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Incremental Discovery | prwatE120 | RDM General Implementation Discussion | 1 | September 29th, 2021 03:18 PM |
| Mute Response Question | sondericker | RDM Interpretation Questions | 13 | January 21st, 2007 10:14 AM |
| Sub-device response to SET/GET DMX512 start address | p_richart | RDM Interpretation Questions | 2 | September 29th, 2006 09:27 AM |
| Discovery Checksum Problem Analysis | nic123 | RDM General Implementation Discussion | 3 | September 24th, 2006 10:25 PM |
| 4.2.1.1 In-line device Port Turnaround during Discovery | prwatE120 | RDM Timing Discussion | 1 | August 7th, 2006 10:52 PM |
Linear Mode
