|
RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
Thread Tools | Search this Thread | Display Modes |
November 20th, 2020 | #1 |
Junior Member
|
Addressing Universes on RDM: Manufacturer PID V ENDPOINT_TO_UNIVERSE
Hello Everyone,
This is my first message, surely not the last one. At Robert Juliat we are working on a new platform and we have an embedded node that can receive Art-Net and Sacn. Also we have one a classic DMX/RDM port. We implemented RDM E1.20 + parts of E1.37-1/-2. We have to address Universes by RDM for Sacn and Art-Net: - Should we use a MANUFACTURER_PID or ENDPOINT_TO_UNIVERSE 0x0903 from E1.37-? - For Art-Net could we use 0 to 32767 to address the universe? Thanks |
November 20th, 2020 | #2 |
Administrator
|
Welcome to the forums Thierry.
I would suggest using the ENDPOINT_TO_UNIVERSE PID from E1.37-7. You will also want to support the ENDPOINT_LIST PID as well for controllers that may be expecting that before using the ENDPOINT_TO_UNIVERSE PID. It's a been a long time since I've cracked open the ArtNet spec but I know the newer versions of it are using sACN underneath so it might work for the later versions of ArtNet. We specifically didn't address use of ArtNet with any of the PIDs as we limited the scope to focusing on sACN as that is the direction everything has been moving towards.
__________________
Scott M. Blair RDM Protocol Forums Admin |
Bookmarks |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PDL size for GET Manufacturer-specific PID | sergeychk | RDM Interpretation Questions | 2 | April 16th, 2020 04:35 AM |
DMX Addressing when Footprint is Zero | Mark_C | RDM General Implementation Discussion | 8 | January 17th, 2010 11:47 AM |
Manufacturer Specific Pids | berntd | RDM General Implementation Discussion | 4 | November 29th, 2009 03:50 PM |
Auto DMX Addressing via RDM ?! | chamber | RDM General Implementation Discussion | 12 | November 11th, 2009 01:47 PM |
RDM Discovery - Effect of Manufacturer IDs | zshenker | RDM General Implementation Discussion | 4 | April 10th, 2009 03:30 PM |