|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
February 2nd, 2014
|
#1 |
|
Junior Member
Join Date: Feb 2014
Location: Brisbane,Australia
Posts: 15
|
Sensor Defintion/Support Parameters
Hi,
I would like to get some support on how to define a temperature sensor using RDM.and also how to use it.(examples would be great) Also would a RDM controller normally have a stock standard supoprt parameter for all the RDM units, or can a RDM controller get support parameters without calling the SUPPORT PARAMTER PROTOCALL. Thanks in advance, Regards George |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| QUEUED_MESSAGE - must controllers support this? | berntd | RDM General Implementation Discussion | 2 | October 31st, 2013 10:06 PM |
| Sensor type and Sensor unit for No of Phases question | berntd | RDM General Implementation Discussion | 1 | October 1st, 2009 10:04 PM |
| Sensor type and Sensor unit for DMX rate question | berntd | RDM General Implementation Discussion | 3 | October 1st, 2009 12:41 AM |
| DMX/RDM support in new SBC | tracyu | RDM Marketplace Discussion | 0 | June 2nd, 2008 05:57 PM |
Threaded Mode