E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old February 2nd, 2014   #1
gthaliath
Junior Member
 
Join Date: Feb 2014
Location: Brisbane,Australia
Posts: 15
Question Sensor Defintion/Support Parameters

Hi,

I would like to get some support on how to define a temperature sensor using RDM.and also how to use it.(examples would be great)

Also would a RDM controller normally have a stock standard supoprt parameter for all the RDM units, or can a RDM controller get support parameters without calling the SUPPORT PARAMTER PROTOCALL.

Thanks in advance,
Regards
George
gthaliath is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
QUEUED_MESSAGE - must controllers support this? berntd RDM General Implementation Discussion 2 October 31st, 2013 10:06 PM
Sensor type and Sensor unit for No of Phases question berntd RDM General Implementation Discussion 1 October 1st, 2009 10:04 PM
Sensor type and Sensor unit for DMX rate question berntd RDM General Implementation Discussion 3 October 1st, 2009 12:41 AM
DMX/RDM support in new SBC tracyu RDM Marketplace Discussion 0 June 2nd, 2008 05:57 PM


All times are GMT -6. The time now is 06:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.