|
|
|||||||
| DMX512 Discussion Discussion and questions relating to DMX512-A and DMX512/1990. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
November 22nd, 2017
|
#1 |
|
Task Group Member
Join Date: Aug 2008
Posts: 390
|
If you want to troubleshoot it, you'll need to look closely at the signal timing (min/max for break length, MAB length, byte spacing, etc.).
There are a lot of poorly implemented DMX devices out there. You may want to try a different LED driver. |
|
|
|
November 29th, 2017
|
#2 |
|
Junior Member
Join Date: Sep 2017
Location: Denmark
Posts: 7
|
Okay and thank you for the answer!
I know for sure that the LED driver is of high quality. I have tried 3 different LED driver models from EldoLED and one LED driver from KKDC. The LED driver from KKDC make the LED flicker, when it receives the DMX signal. Does that tell you anything? I will try to get an oscilloscop to check out the timing of the signal. Best regards Christian |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| JESE DMX-TRI RDM USB Controller | hamish | RDM Marketplace Discussion | 4 | January 6th, 2020 05:59 PM |
| Sensor type and Sensor unit for DMX rate question | berntd | RDM General Implementation Discussion | 3 | October 1st, 2009 12:41 AM |
Hybrid Mode
