|
|
|||||||
| RDM Interpretation Questions Discussion and questions relating to interpreting and understanding the E1.20 RDM Standard. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
March 7th, 2011
|
#1 |
|
Administrator
Join Date: Feb 2006
Posts: 441
  |
The 2011 version is beyond change at this point. It basically means starting the process all over again.
We did make changes in the 2011 version in this area. The following sentence was added to Lowest and Highest Detected values as well as the Recorded Value: "If this value is not supported, then this field shall be set to 0x0000." As Eric said, a controller can determine whether a responder supports the functionality by looking at the bit field in the Sensor Definition message and if they are not supported then we have explicitly said what the fields should stuff now.
__________________
Scott M. Blair  RDM Protocol Forums Admin |
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reset sensor data of all sensors | sjackman | RDM Interpretation Questions | 1 | January 20th, 2008 06:47 PM |
Hybrid Mode
