Mute Response Question - E1.20 RDM (Remote Device Management) Protocol Forums

porubat · September 21st, 2006

when I have begun whit RDM implementation i used a simple converter with an PIC processor, but the conversion from fixtrure to the commputer was slow. Then i used little bit upgraded OPEN DMX USB. When I implemented the discovery methods, sometimes I had the situations that the collision packet had good checksum, but I catched collisions to. Finaly I have implemented the discovery in this way: I'm searching throught the tree in the active branches (multiple response or discovery respons in the branch). As lately as at the top of the tree I store the UID and mute the device
.
Tomas

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
broadcast Disvovery Mute/Unute	berntd	RDM Interpretation Questions	2	April 8th, 2008 10:07 PM
Discovery Response Preamble	prwatE120	RDM General Implementation Discussion	0	January 20th, 2007 12:22 AM
Sub-device response to SET/GET DMX512 start address	p_richart	RDM Interpretation Questions	2	September 29th, 2006 09:27 AM
Discovery Mute/Un mute	nic123	RDM Interpretation Questions	1	June 14th, 2006 10:28 AM

September 21st, 2006	#1
porubat Junior Member Join Date: Sep 2006 Posts: 9	when I have begun whit RDM implementation i used a simple converter with an PIC processor, but the conversion from fixtrure to the commputer was slow. Then i used little bit upgraded OPEN DMX USB. When I implemented the discovery methods, sometimes I had the situations that the collision packet had good checksum, but I catched collisions to. Finaly I have implemented the discovery in this way: I'm searching throught the tree in the active branches (multiple response or discovery respons in the branch). As lately as at the top of the tree I store the UID and mute the device . Tomas