RDM Controller timing clarification - E1.20 RDM (Remote Device Management) Protocol Forums

gthaliath · May 15th, 2014

Hi Scott,
We have been working on responders and while doing a discovery with different RDM controllers they all come up with diffrerent numbers.

We had a test setup of 32 nodes on a network(1km long) and the controller used where

1.Controll Freak(ADDICT)
2.ENTTEC(RDM USB pro)
3.DMXter 4 RDM

out of which the second two worked fine.
But the ADDICT was showing numbers all over the place.(26 to 34)(34 when it was showing address not on the network, no way or cross talk from any other devices just a random address)

how could we check if the responders on the network are working fine in respect to timing.

Regards
George

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ENTTEC RDM controller (subdevices)	nic123	RDM Marketplace Discussion	3	October 24th, 2007 12:03 AM
Time between controller packets	Dan Scheurell	RDM Timing Discussion	1	April 1st, 2007 11:38 PM
Welcome to the RDM Timing Discussion Forum	sblair	RDM Timing Discussion	0	May 31st, 2006 10:58 PM

May 15th, 2014	#3
gthaliath Junior Member Join Date: Feb 2014 Location: Brisbane,Australia Posts: 15	Hi Scott, We have been working on responders and while doing a discovery with different RDM controllers they all come up with diffrerent numbers. We had a test setup of 32 nodes on a network(1km long) and the controller used where 1.Controll Freak(ADDICT) 2.ENTTEC(RDM USB pro) 3.DMXter 4 RDM out of which the second two worked fine. But the ADDICT was showing numbers all over the place.(26 to 34)(34 when it was showing address not on the network, no way or cross talk from any other devices just a random address) how could we check if the responders on the network are working fine in respect to timing. Regards George