LAMP ON MODE - E1.20 RDM (Remote Device Management) Protocol Forums

-dalc- · June 24th, 2009

As an engineer, I agree with you. But LJs and service technicians don't reason in the same manner (Also I've noticed that professional users have opposite ideas from low end users...).
I was explicitally requested to implement a single step process for striking the lamp, so I'll implement "LAMP FORCED OFF" mode as a "manufacturer specific mode".
Howewer I think It could be a good thing for controllers to set "lamp on mode" to "LAMP ON MODE ON" or "LAMP ON MODE OFF" before sending a set "lamp state" comand (so lamp handling returns totally under the control of the controller).

June 24th, 2009	#6
-dalc- Junior Member Join Date: Feb 2009 Posts: 7	As an engineer, I agree with you. But LJs and service technicians don't reason in the same manner (Also I've noticed that professional users have opposite ideas from low end users...). I was explicitally requested to implement a single step process for striking the lamp, so I'll implement "LAMP FORCED OFF" mode as a "manufacturer specific mode". Howewer I think It could be a good thing for controllers to set "lamp on mode" to "LAMP ON MODE ON" or "LAMP ON MODE OFF" before sending a set "lamp state" comand (so lamp handling returns totally under the control of the controller).