|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
November 20th, 2020
|
#2 |
|
Administrator
Join Date: Feb 2006
Posts: 441
  |
Welcome to the forums Thierry.
I would suggest using the ENDPOINT_TO_UNIVERSE PID from E1.37-7. You will also want to support the ENDPOINT_LIST PID as well for controllers that may be expecting that before using the ENDPOINT_TO_UNIVERSE PID. It's a been a long time since I've cracked open the ArtNet spec but I know the newer versions of it are using sACN underneath so it might work for the later versions of ArtNet. We specifically didn't address use of ArtNet with any of the PIDs as we limited the scope to focusing on sACN as that is the direction everything has been moving towards.
__________________
Scott M. Blair  RDM Protocol Forums Admin |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PDL size for GET Manufacturer-specific PID | sergeychk | RDM Interpretation Questions | 2 | April 16th, 2020 03:35 AM |
| DMX Addressing when Footprint is Zero | Mark_C | RDM General Implementation Discussion | 8 | January 17th, 2010 10:47 AM |
| Manufacturer Specific Pids | berntd | RDM General Implementation Discussion | 4 | November 29th, 2009 02:50 PM |
| Auto DMX Addressing via RDM ?! | chamber | RDM General Implementation Discussion | 12 | November 11th, 2009 12:47 PM |
| RDM Discovery - Effect of Manufacturer IDs | zshenker | RDM General Implementation Discussion | 4 | April 10th, 2009 02:30 PM |
Threaded Mode