Discovery response format - E1.20 RDM (Remote Device Management) Protocol Forums

FishFood6 · November 19th, 2020

I have looked at the RS485 linef with an oscilloscope, but I haven't had the chance to use a digital oscilloscope so the signal is just there for one second and gone the next. The moment the signal is there does correlate with when I'm sending the signal, so I am left to asume that the right signal is being send.

As for the sniffers, thank you for the recommendations, I'll have to look into them.

I have also switched off of auto-direction in the past few days. It's generally better to have more control over things like that.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Discovery Response Preamble	prwatE120	RDM General Implementation Discussion	0	January 20th, 2007 12:22 AM

November 19th, 2020	#5
FishFood6 Junior Member Join Date: Nov 2020 Posts: 3	I have looked at the RS485 linef with an oscilloscope, but I haven't had the chance to use a digital oscilloscope so the signal is just there for one second and gone the next. The moment the signal is there does correlate with when I'm sending the signal, so I am left to asume that the right signal is being send. As for the sniffers, thank you for the recommendations, I'll have to look into them. I have also switched off of auto-direction in the past few days. It's generally better to have more control over things like that.