|
|
|||||||
| RDM Timing Discussion Discussion and questions relating to the timing requirements of RDM. |
|
|
Thread Tools | Search this Thread | Display Modes |
May 15th, 2014
|
#3 |
|
Junior Member
Join Date: Feb 2014
Location: Brisbane,Australia
Posts: 15
|
Hi Scott,
We have been working on responders and while doing a discovery with different RDM controllers they all come up with diffrerent numbers. We had a test setup of 32 nodes on a network(1km long) and the controller used where 1.Controll Freak(ADDICT) 2.ENTTEC(RDM USB pro) 3.DMXter 4 RDM out of which the second two worked fine. But the ADDICT was showing numbers all over the place.(26 to 34)(34 when it was showing address not on the network, no way or cross talk from any other devices just a random address) how could we check if the responders on the network are working fine in respect to timing. Regards George |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ENTTEC RDM controller (subdevices) | nic123 | RDM Marketplace Discussion | 3 | October 24th, 2007 12:03 AM |
| Time between controller packets | Dan Scheurell | RDM Timing Discussion | 1 | April 1st, 2007 11:38 PM |
| Welcome to the RDM Timing Discussion Forum | sblair | RDM Timing Discussion | 0 | May 31st, 2006 10:58 PM |
Threaded Mode