FRAMING ERROR Detection method - E1.20 RDM (Remote Device Management) Protocol Forums

prwatE120 · March 8th, 2012

A bigger issue in timing accuracy may well be the latency of your interrupt handler. Nigel has already noted that the time between the start bit and the UART's determination of a FE will be failry consistent. Of course you also need to consider the "data" the UART acquired at the time of the FE. If it is not 0x00, it may well be a FE, but is most certainly not the beginning of a BREAK.

Peter

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

March 8th, 2012	#7
prwatE120 Task Group Member Join Date: Jun 2006 Posts: 181	A bigger issue in timing accuracy may well be the latency of your interrupt handler. Nigel has already noted that the time between the start bit and the UART's determination of a FE will be failry consistent. Of course you also need to consider the "data" the UART acquired at the time of the FE. If it is not 0x00, it may well be a FE, but is most certainly not the beginning of a BREAK. Peter