RDM software system for POS - E1.20 RDM (Remote Device Management) Protocol Forums

sblair · August 25th, 2011

Steve,

I'm not certain if you're in the correct place, you might be... These forums are geared towards supporting the ANSI E1.20 Standard. Which is a remote device management protocol over RS485 primarily for lighting products. That does not mean that it can't easily be adapted to be used with other types of products as well.

You might check out the Wikipedia page which will give you a high-level overview of the protocol: http://en.wikipedia.org/wiki/RDM_(lighting)

August 25th, 2011	#2
sblair Administrator Join Date: Feb 2006 Posts: 441	Steve, I'm not certain if you're in the correct place, you might be... These forums are geared towards supporting the ANSI E1.20 Standard. Which is a remote device management protocol over RS485 primarily for lighting products. That does not mean that it can't easily be adapted to be used with other types of products as well. You might check out the Wikipedia page which will give you a high-level overview of the protocol: http://en.wikipedia.org/wiki/RDM_(lighting) __________________ Scott M. Blair RDM Protocol Forums Admin

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ENTTEC RDM Software Available	nic123	RDM Marketplace Discussion	0	August 4th, 2006 01:38 AM