Missing RDM pararameters - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · July 15th, 2010

Playing devil's advocate for the sake of discussion:

The units in table A-13 "Sensor Unit Defines" are all derived from the SI Base Units (Meters/Kilograms/Seconds). In this system, a percentage is a unit-less value, thus UNITS_NONE is the most technically correct.

A percentage is unit-less because it is the ratio of two values with the same units. Thus the two units cancel out resulting in a dimensionless value.

For a fog fluid sensor, you could define a SENS_VOLUME with UNITS_NONE and a description string of "Fluid Level (percent)"

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

July 15th, 2010	#3
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	Playing devil's advocate for the sake of discussion: The units in table A-13 "Sensor Unit Defines" are all derived from the SI Base Units (Meters/Kilograms/Seconds). In this system, a percentage is a unit-less value, thus UNITS_NONE is the most technically correct. A percentage is unit-less because it is the ratio of two values with the same units. Thus the two units cancel out resulting in a dimensionless value. For a fog fluid sensor, you could define a SENS_VOLUME with UNITS_NONE and a description string of "Fluid Level (percent)"