What is the basic requirement to implement RDM? - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · June 25th, 2009

Just about any 8-bit microcontroller with a UART and a few K-bytes of flash should be sufficient for RDM. Add more flash if you want to program in C instead of assembly, and having >1K-byte of RAM makes things easier. Many RDM products have been built with PICs (16F and 18F series) and 8051 derivatives.

For the most complex products that are likely to need a Full Featured responder, the resources needed to support RDM will be insignificant compared the total computational load on the processor.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

June 25th, 2009	#16
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	Just about any 8-bit microcontroller with a UART and a few K-bytes of flash should be sufficient for RDM. Add more flash if you want to program in C instead of assembly, and having >1K-byte of RAM makes things easier. Many RDM products have been built with PICs (16F and 18F series) and 8051 derivatives. For the most complex products that are likely to need a Full Featured responder, the resources needed to support RDM will be insignificant compared the total computational load on the processor.