View Single Post
Old June 12th, 2009   #7
Nigel Worsley
Junior Member
 
Join Date: Jun 2006
Location: London
Posts: 13
Default

Quote:
Originally Posted by wcai_cypress View Post
Because I am a firmware engineer, I have one more stupid question, normally, the UART module in MCU works in full-duplex mode, how to make it work in half-duplex mode.
The easiest way is not to bother!

Tie the RS485 driver chip's Driver Enable signal to the Not Receive Enable and the UART will never see the transmit data in the first place.
Nigel Worsley is offline   Reply With Quote